固定升降機http://www.qdysj.net/原來的安裝掛線要求測量只給定中心線與主軸中心線即可，通過以往的安裝證明，這種十字掛線法容易形成累計偏差誤差。中心線與提升中心線水平距離在支胎中就很難掌握，由于胎板釘有許多支柱，往往擋住測量通路，用米尺直接測量較困難，只有采取分段法測量，這樣就產生較大的累計偏差。就是能用尺子直接測量，如所測量方向如與雙提中心線不垂直，或者兩方面不平行都導致固定升降機中心線存在誤差，其余的如電動機中心線產生的累計偏差將會更大。
Fixed lifts original installation hung required to measure only given spindle centerline to centerline, by the previous installation has proved that this method is easy to form cross-thread the cumulative deviation errors. Centerline and upgrading the centerline horizontal distance in supporting the womb is difficult to grasp, because the fetus has many pillars nail plate, often blocking the measurement path, the more difficult to directly measure with a meter stick, only to take sub measurement, thus creating a greater cumulative deviation. Is the ruler can be measured directly, such as the measurement direction is not perpendicular to the center line and double-lift, or both are not parallel to the centerline of the presence of error results in a fixed elevator, the rest of the motor as the cumulative deviation of the center line produced will be greater.
　   
通過對固定升降機http://www.qdysj.net/安裝易出現的誤差的分析，采取行之有效的控制產生誤差的對策，采取的對策是采用多控制線安裝法，即在測量人員掛線時，除掛好原主軸中心線與提升中心線外，還應增中心線及電動機中心線。在支胎過程中，一些關鍵尺寸都從控制線開始量。使固定升降機鹼基礎偏差、天輪基礎偏差及機械主體安裝偏差都嚴格控制在設計要求的范圍之內，特別是有效地控制累計誤差的產生安裝工程的成敗起著關鍵性的作用。
Through the analysis of fixed lift installation error prone, and take effective countermeasures to control produce errors, measures are taken to control the use of multi-line installation method, which hung in the measurement of personnel, in addition to the original spindle centerline and hang enhance the centerline, but also increase the centerline and motor centerline. In support fetal process, some key dimensions are increased from the beginning of the line of control. The fixed lift alkaline base bias, bias-day basis and mechanical main wheel misalignment are strictly controlled in the range of design requirements, particularly effective in controlling the success of the cumulative error generated installation engineering plays a key role.