河北升降貨梯鏈傳動的布置應注意以下幾點:

1、河北升降貨梯http://www.qdysj.net/兩鏈輪中心連線最好成水平或與水平面成45度以下傾角。
Shandong cargo lifter best line connecting the centers of two sprocket horizontally or below 45 degrees with the horizontal angle.

2、河北升降貨梯兩輪軸線在同一鉛垂面內時，鏈的下垂量集中在下端，所以要盡量避免這種垂直或接近垂直的布置，否則會減少下面鏈輪的有效嚙合齒數，降低傳動能力。河北升降貨梯上、下兩輪錯開，使其軸線不在同一鉛垂面內；中心距可調；加設張緊裝置；盡可能將小鏈輪布置在上方。
Shandong rounds cargo lifter axis in the same vertical plane, the amount of sag chain concentrated in the lower end, so try to avoid such a vertical or near vertical arrangement, otherwise it will reduce the effective number of teeth of

the sprocket below, lower transmission capacity. Shandong cargo lifter, under two rounds of staggered, so that its axis is not in the same vertical plane; center distance adjustable; plus set tensioning device; as the small sprocket arranged above.

3、無論河北升降貨梯http://www.qdysj.net/兩輪軸線在同一水平面上或不在同一水平面上，都應使松邊布置在下面，否則松邊下垂量增大后，鏈條易與小鏈輪干涉或松邊會與緊邊相碰，此外，需經常調整中心距。
Whether Shandong cargo lifter axis in two rounds or not in the same horizontal plane in the same horizontal plane, should make the loose side arranged underneath, otherwise the amount of sag increases the loose side, chain sprocket easily with little interference or loose side will be consistent with the tight side touch, in addition, the need to constantly adjust the center distance.